diff --git a/reverse_proxy.md b/reverse_proxy.md
index f298d03..7ca43bc 100644
--- a/reverse_proxy.md
+++ b/reverse_proxy.md
@@ -1,9 +1,9 @@
-### Reverse Proxy using a VPS
+# Reverse Proxy using a VPS
 
 
 This is a guide to create a reverse proxy using a Virtual Private Server, or VPS so that you can access internally hosted services. 
 
-# My Situation
+## My Situation
 
 I host some services from my home lab that I access remotely, such as Home Assistant. 
 
@@ -18,7 +18,7 @@ I have configured a router of my own with, with all traffic sent via [Mullvad VP
 
 Now I need to be able to access my internal services externally, using this same internet connection.
 
-# The Plan
+## The Plan
 
 There are some ways I can do this:
 
@@ -41,7 +41,7 @@ To make this, I need a few things:
     -   Be sure to check how much network traffic the VPS allows. Lots have limits, which may or may not be enough for your use case. I am streaming 4k video so I am looking for unlimited bandwidth.
 2.  A router that allows for new VPN interfaces to be created. I use [opnSense](https://opnsense.org/) for my router which does allow this.
 
-# VPS Setup
+## VPS Setup
 
 First I need to find a VPS provider. As I said before, I went with a server from [OVHcloud](https://www.ovhcloud.com/en/).
 
@@ -66,7 +66,7 @@ Once I purchased the server and it had provisioned, I connected and set up a few
         `sudo ufw enable`
 4.  Enabled the edge firewall on my hosting provider. 
 
-# VPN Setup
+## VPN Setup
 
 After this it is time to install WireGuard VPN on the VPS.
 
@@ -95,9 +95,8 @@ For the gateway, it does not matter, just as long as it is unique.
 
 Then in the Peers tab:
 
-The Pubic Key is the Public key from the WireGuard Server on the VPS
-
-The Endpoint Address is the public IP of the VPS.
+- The Pubic Key is the Public key from the WireGuard Server on the VPS
+- The Endpoint Address is the public IP of the VPS.
 
 ![](images/wireguard_peer.png)
 
@@ -128,7 +127,7 @@ AllowedIPs = 10.0.20.0/24, 10.0.10.0/24
 PersistentKeepalive = 25
 ```
 
-# Network Setup
+## Network Setup
 
 Now an interface needs to be created on my router for the new VPN connection so that I can configure firewall rules to allow and deny access. 
 
@@ -148,7 +147,7 @@ After this, I created the below firewall rule so that the new WireGuard interfac
 
 If you have any strange issues, check the routing table (System > Routes > Status) to see if there are any old entries that need to be deleted. 
 
-# Reverse Proxy
+## Reverse Proxy
 
 For the reverse Proxy I am using [Nginx Reverse Proxy Manager](https://nginxproxymanager.com/) running in a Docker container.